Here are some pics.
St George:
un-named:
Tulio (looks excatly like mine except for the headstock mount cover) - guess this name needs to be added to the list:
Statistics: Posted by cyclone3d — Fri Dec 17, 2010 8:43 am
]]>
I did find a wiring pic of a different teisco on teisco twangers, but their page is down at the moment. edit: their page is back up... here are the pics in question.
/edit
The pic on that page showed a 50k resistor going across each pickup switch. Anybody have any idea what that kind of setup would do?
The switches on mine are currently wired as hard on/off switches.
Statistics: Posted by cyclone3d — Thu Dec 16, 2010 4:16 pm
]]>
It is a Kimberly Twin (Teisco EJ-2). I got it from a local thrift shop and have been working on getting it working properly.
So far I have fixed the output plug and redone some of the wiring. At some time in the past, somebody redid the wiring, probably when replacing the pots and did it all wrong.
Stuff wasn't grounded properly and the tone control was hooked up all wrong and didn't do anything at all.
The volume controls were wired backwards as well.
I used a generic wiring diagram off of
to get it working.
Does anybody have any pics or have a diagram of the original wiring on one of these?
Currently all 3 pots are identical 500k pots and the cap for the tone control is labeled .001.
I would very much like to know if the pots and the cap are the correct values for this guitar, especially since the tone control doesn't do a whole lot - it is barely noticeable.
Statistics: Posted by cyclone3d — Wed Dec 15, 2010 8:11 pm
]]>