The VintAxe Guitar Forum
A Place for Vintage Guitar Enthusiasts to Pursue their Passion
Thinking of adding a blender pot to my kawai
Moderators: cheepaxes, VintAxe, Phizix
2 posts
• Page 1 of 1
This is a cool little guitar but it tends to get a little muddy. I was thinking of replacing the tone knob with a pickup blender knob, since theres no other way to switch between pickups on the guitar. Anyone have any comments or suggestions? I'm not so sure about the wiring and I doubt theres any schematics for this configuration. Heres a picture of what I have to work with:
- 86SG
- Posts: 3
- Joined: Thu May 31, 2007 10:16 pm
- Location: Ma
Hi 86SG,
The only blender pot I'm aware of is for a Strat 3 pickup configuration. Here is a schematic for the 3 pickup configuration taken from Lindy Fralin's website:
There may be blender pots for 2 pup configurations that I'm not aware of but if they exist, Lindy Fralin will know. You can call them at 804-358-2699 and ask them about what you are trying to do.
Visit Lindy Fralin's website here:
The only blender pot I'm aware of is for a Strat 3 pickup configuration. Here is a schematic for the 3 pickup configuration taken from Lindy Fralin's website:
There may be blender pots for 2 pup configurations that I'm not aware of but if they exist, Lindy Fralin will know. You can call them at 804-358-2699 and ask them about what you are trying to do.
Visit Lindy Fralin's website here:
-
VintAxe - Site Admin
- Posts: 2196
- Joined: Sat Jul 15, 2006 10:52 am
- Location: USA
2 posts
• Page 1 of 1